<div><p><br></p><p>ForeverFit self-adjusting shanks are the easiest for the consumer to wear. They simply slip on and off without latches or buttons. For the bench jeweler, they are about as easy to install as “half-shanking” any ring. Simply measure the customer's ring size normally and if necessary, reshape her ring to the next whole size above her knuckle size. Then replace the lower portion of her ring with the ForeverFit mechanism. No solder is used in assembling the ForeverFit shank so there is no danger of freezing the mechanism, even with conventional torch soldering. The stainless steel leaf spring floats under the finger cradle and is easily removed before soldering to prevent the loss of spring tension. ForeverFit shanks allow the jeweler to retain up to two thirds of the customer’s original ring. ForeverFit shanks may also serve as plain wedding bands in 2.5, 4 and 6mm widths.</p>
<ul>
<li>After      sizing customers ring,&nbsp;cut off the bottom.</li>
<li>Cut      the&nbsp;ForeverFit™&nbsp;shank to line up with the customer's shank.</li>
<li>Later      press out the .021 inch pins with a mini arbor press or simply reverse a      #77 or smaller drill bit in the chuck of a small drill press. Leave a 1/4      inch or less extending.&nbsp; Do not&nbsp;hammer&nbsp;or bend the inward      on the cut areas of the adjustable shank. Do not apply direct heat to the      spring. Protect it with heat sink material or remove.</li>
<li>Take      customer's ring and align with the bottom of the&nbsp;ForeverFit™&nbsp;shank.</li>
<li>The      components are precision fit, do not attempt to alter the ring after      assembly.</li>
</ul><div><br></div><br></div>

This item is no longer available.